2 d

If the heater is blowing cool air,?

step 2 :Installing the Air Temperature Door Actuator Mak?

Turn OFF the ignition key and wait for 1 minute. However, all models have at least two blend door actuators. Step 2: Align the Actuator's Output Shaft Gears. Using a 50/50 mix of anti-freeze and distilled water, top off the radiator and fill the coolant reservoir tank to the. craigslist portland oregon apartments An HVAC blend door actuator in a truck or a car controls the airflow and the temperature. 4) Rotate the door linkage until it is in approximately the center of its travel. I'm assuming I have a bad actuator. In auto mode you will see the fan speed auto adjusting up and down. tiny houses for sale in jacksonville florida StandardDelivery by July 11 Notes: At heater, A/C module. Install the floor air outlet duct extension (1) to the floor air duct (2). GM OE and ACDelco are the same in this case, both part numbers on the same box. To determine if this is the problem, when the engine is cool, remove the radiator cap. dartconnect You can easily do it yourself. ….

Post Opinion